Appendix 1.4 Axis Specifications Parameters - Mitsubishi Electric C70 Setup Manual

Appendix 1.4 Axis Specifications Parameters

The parameters with "(PR)" requires the CNC to be turned OFF after the settings. Turn the power OFF and ON to enable
the parameter settings.
【#2001】 rapid Rapid traverse rate
Set the rapid traverse feedrate for each axis.
(Note) The maximum value to be set depends on the machine specifications.
---Setting range---
1 to 1000000 (mm/min)
【#2002】 clamp Cutting feedrate for clamp function
Set the maximum cutting feedrate for each axis.
Even if the feedrate in G01 exceeds this value, the clamp will be applied at this feedrate.
---Setting range---
1 to 1000000 (mm/min)
Appendix 1.4 Axis Specifications Parameters
C70 Setup Manual
231