Mitsubishi Electric C70 Setup Manual page 53

MITSUBISHI CNC
2 GOT Initial Setup
(4) Select the following item from among the pull-down menu, and click "Next >".
Communication Driver: MELSEC-QnU, Q17nD/M/NC/DR, CRnD-700
(5) Select the following item from among the pull-down menu, and click "Next >".
I/F: Extend I/F-1(1st)
(Note) Select "Extend I/F-2(1st)" when the Ethernet communication unit is mounted on the GOT rear slot IF-2.
(6) Select the following item from among the pull-down menu.
Communication driver: Ethernet(MELSEC), Q17nNC, CRnD-700
Then click "Details".
36