Mitsubishi Electric C70 Setup Manual page 374

【#29053(PR)】 Byte module count Slave node: Byte module count
Set the number of byte modules of the slave node.
Set a hexadecimal number.
HEX-
HEX-1,2 : Input byte module count
Set the number of input byte modules.
HEX-3,4 : Output byte module count
Set the number of output byte modules.
【#29054(PR)】 Word module count Slave node: Word module count
Set the number of word modules of the slave node.
Set a hexadecimal number.
HEX-
HEX-1,2 : Input word module count
Set the number of input word modules.
HEX-3,4 : Output word module count
Set the number of output word modules.
【#29055(PR)】 Double-word module count Slave node: Double-word module count
Set the double-word module count of the slave node.
Set a hexadecimal number.
HEX-
HEX-1,2 : Input double-word module count
Set the number of input double-word modules.
HEX-3,4 : Output double-word module count
Set the number of output double-word modules.
【#29056(PR)】 Expected packet rate Slave node: Expected packet rate
Set the expected packet rate of the slave node.
Setting details vary depending on the connection type.
The standard setting is "0".
"0" is regarded as 200(ms).
Other settings are regarded as "(Set value) - 1"(ms).
---Setting range---
0 to 65535(ms)
【#29057(PR)】 Watchdog timeout action Slave node: Watchdog timeout action
Set the operation during watchdog timeout at the slave node.
The standard setting is "0".
0000(HEX), 0001(HEX): TIMEOUT; the connection is placed in timeout state. It will not be recovered
until an operator stops the communication and then resumes it.
0002(HEX): AUTO DELETE; the connection is automatically deleted. At this time the communication
stops once, then resumes automatically. The output is cleared once.
0003(HEX): AUTO RESET; the communication continues while connection is maintained. The
output is not cleared.
4 3 2 1
4 3 2 1
4 3 2 1
C70 Setup Manual
Appendix 1.9 DeviceNet Parameters
357