Mitsubishi Electric C70 Setup Manual page 274

For SV017/bitF-C = 3 (400V standard motor series)
HF-H75
HF-H105 : 02h,
HF-H54
HF-H104 : 04h,
HF-H154 : 05h,
HF-H204 : 07h,
HF-H354 : 08h,
HF-H453 : 09h,
HF-H703 : 0Ah
HF-H903 : 0Bh,
HC-H1502: B9h
For linear motor and direct-drive motor, follow the settings stated in respective materials.
【#2226】 SV026 OD2 Excessive error detection width during servo OFF
Set the excessive error detection width during servo OFF.
When set to "0", the excessive error alarm detection will be ignored, so do not set to "0".
<Standard setting value>
OD1=OD2= (Rapid traverse rate [mm/min]) / (60×PGN1) / 2 [mm]
Related parameters: SV023
---Setting range---
0 to 32767 (mm)
However, when SV084/bitC=1, the setting range is from 0 to 32767 (μm).
: 01h, HP-H54
HP-H104 : 12h
: 03h, HP-H154 : 13h
HP-H204 : 14h
HP-H354 : 15h
HP-H454 : 16h
HP-H704 : 17h
HP-H903 : 18h
HP-H1103: 19h
HP-H224 : 1Bh
Appendix 1.5 Servo Parameters
: 11h
C70 Setup Manual
257