Mitsubishi Electric C70 Setup Manual page 202

【#1081】 Gmac_P Give priority to G code parameter
Select the G code priority relationship during the macro call with G command.
0: Priority is on G code used in the system
1: Priority is on registered G code for call
【#1082】 Geomet Geometric
Select the type of geometric to use.
0: Not use
1: Use only geometric I
2: Use geometric I and IB
With geometric, specific address codes are used for exclusive meanings. Thus, if A or C is used for
the axis name or 2nd miscellaneous command code, the A used for the axis name may function as
the geometric's angle designation. Pay special attention to axis names, etc., when using this
function.
【#1084】 RadErr Arc error
Set the tolerable error range when the end point deviates from the center coordinate in the circular
command.
---Setting range---
0 to 1.000 (mm)
【#1085】 G00Drn G00 dry run
Select whether to apply dry run (feed at manual setting speed instead of command feedrate) to the
G00 command.
0: Not apply to G00. (move at rapid traverse rate)
1: Apply to G00. (move at manual setting speed)
【#1086】 G0lntp G00 non-interpolation
Select the G00 travel path type.
0: Move linearly toward the end point. (interpolation type)
1: Move to the end point of each axis at the rapid traverse feedrate for each axis. (non-
(Note) If this parameter is set to "1", neither of the following functions will be available: rapid traverse
【#1087】 G96_G0 Constant surface speed control by rapid traverse feed command
Select how to handle the surface speed for the G00 command when using the constant surface
speed control function.
0: Calculate the surface speed constantly even during G00 movement
1: Calculate the surface speed at the block end point in the G00 command
【#1088】 G30SL Disable G30 soft limit
Select how to handle the soft limit during G30 (2nd reference position return).
0: Enable
1: Disable
【#1089】 Cut_RT
Not used. Set to "0".
【#1090】 Lin_RT
Not used. Set to "0".
【#1091】 Mpoint Ignore middle point
Select how to handle the middle point during G28 and G30 reference position return.
0: Pass the middle point designated in the program and move to the reference position.
1: Ignore the middle point designated in the program and move straight to the reference position.
interpolation)
constant inclination acceleration/deceleration.
Appendix 1.3 Base Specifications Parameters
C70 Setup Manual
185