Mitsubishi Electric C70 Setup Manual page 224

【#1229】 set01
bit0: Subprogram interrupt
Select the type of the user macro interrupt.
0: Macro type user macro interrupt
1: Sub-program type user macro interrupt
bit1: Accurate thread cutting E
Select what the address E specifies in inch screw cutting.
0: Number of threads per inch
1: Precision lead
bit2: Radius compensation type B (for M system only)
Select the method of the arithmetic processing for the intersection point when the start-up or cancel
command is operated during radius compensation.
0: The processing does not handle the start-up or cancel command block: handle the offset vector
1: The processing is executed for the intersection point between the command block and the next
bit2: Nose R compensation type B (for L system only)
Select the method of the arithmetic processing for the intersection point when the start-up or cancel
commands are operated during nose R compensation.
0: The processing does not handle the start-up or cancel command block: handle the offset vector
1: The processing is executed for the intersection point between the command block and the next
bit3: Initial constant surface speed
Select the initial state after the power-ON.
0: Constant surface speed control cancel mode
1: Constant surface speed control mode
bit4: Synchronous tap
Select the operation when ",R" is omitted in G74/G84 tapping cycle.
0: Asynchronous tap
1: Synchronous tap
bit6: Grid display selection
Select the grid display type on the servo monitor screen during the dog type reference position
return.
0: Distance between dog OFF and basic point (including a grid mask amount)
1: A value given by reducing a grid mask amount from the distance between dog OFF and basic
【#1234】 set06
bit5: Enable sampling parameter output
Select whether to enable sampling parameter.
0: Disable
1: Enable
Sampling parameter will be put out only when this parameter is enabled and "#1224 aux08/bit0" =
"1".
【#1236】 set08
bit0: Rotary axis Manual feed rate unit selection
Select the manual feed rate unit for a rotary axis.
0: Fixed to [°/min]
1: Conventional
in the direction vertical to that of the command instead.
block.
in the direction vertical to that of the command instead.
block.
point
Appendix 1.3 Base Specifications Parameters
C70 Setup Manual
207