Mitsubishi Electric C70 Setup Manual page 550

P275 MACRO ARG. EX.
Details
The number of argument sets in the macro call argument type II has exceeded the limit.
Remedy
- Correct the program.
P276 CALL CANCEL
Details
A G67 command was issued though it was not during the G66 command modal.
Remedy
- Correct the program.
- Issue G66 command before G67 command, which is a call cancel command.
P277 MACRO ALM MESG
Details
An alarm command has been issued in #3000.
Remedy
- Refer to the operator messages on the diagnosis screen.
- Refer to the instruction manual issued by the machine tool builder.
P280 EXC. [ ‚ ]
Details
Over five times have the parentheses "[" or "]" been used in a single block.
Remedy
- Correct the program so that the number of "[" or "]" is five or less.
P281 [ ‚ ] ILLEGAL
Details
A single block does not have the same number of commanded parentheses "[" as that of "]".
Remedy
- Correct the program so that "[" and "]" parentheses are paired up properly.
P282 CALC. IMPOSS.
Details
The arithmetic formula is incorrect.
Remedy
- Correct the formula in the program.
P283 DIVIDE BY ZERO
Details
The denominator of the division is zero.
Remedy
- Correct the program so that the denominator for division in the formula is not zero.
P290 IF SNT. ERROR
Details
There is an error in the "IF[<conditional>]GOTO(" statement.
Remedy
- Correct the program.
P291 WHILE SNT. ERR
Details
There is an error in the "WHILE[<conditional>]DO(-END(" statement.
Remedy
- Correct the program.
C70 Setup Manual
Appendix 2.13 Program Errors (P)
533