List Of Parameters; Basic Parameters 1 - Mitsubishi Electric MELSEC-Q Series User Manual

5.2 List of parameters

5.2.1 Basic parameters 1

Item
[Pr.1] Unit setting
[Pr.2]
Number of pulses per
rotation (AP)
(Unit : PLS)
[Pr.3]
Movement amount per
rotation (AL)
[Pr.4]
Unit magnification (AM)
[Pr.7]
Bias speed at start
The setting items of the setting data are explained in this section.
• Guide to buffer memory address
In the buffer memory address, "n" in "1+150n", etc. indicates a value corresponding
to axis No. such as the following table.
Axis No. n Axis No.
1 0
2 1
3 2
4 3
(Note-1): Calculate as follows for the buffer memory address corresponding to each axis.
(Example) For axis No. 16
1+150n ([Pr.4] Unit magnification (AM)) = 1+150 15 = 2251
Setting value, setting range
Value set with GX Works2
0 : mm
1 : inch
2 : degree
3 : PLS
1 to 200000000
The setting value range differs according to the "[Pr.1] Unit
setting".
1 : 1 times
10 : 10 times
100 : 100 times
1000 : 1000 times
The setting value range differs according to the "[Pr.1] Unit
setting".
Chapter 5 Data Used for Positioning Control
n Axis No.
5 4 9
6 5 10
7 6 11
8 7 12
Value set with sequence
program
0
1
2
3
1 to 200000000
1
10
100
1000
5 - 20
n Axis No. n
8 13 12
9 14 13
10 15 14
11 16 15
Default
Buffer memory address
value
3
20000
20000
1
0
0+150n
2+150n
3+150n
4+150n
5+150n
1+150n
6+150n
7+150n
n: Axis No.-1