4.1 Outline of installation, wiring and maintenance
4.1.1 Installation, wiring and maintenance procedures
Module mounting
Mount the QD77GF to the base unit.
Wiring
Connect external devices to the QD77GF.
Checking wiring
Check wiring with GX Works2.
Perform parameter
and data setting with
GX Works2?
Parameter setting and auto refresh setting
Perform each setting with GX Works2.
Programming and debugging
Create and debug sequence programs.
Start operation
The outline and procedures for Simple Motion module installation, wiring and
maintenance are shown below.
Start
YES
Maintenance
End
Chapter 4 Installation, Wiring and Maintenance of the Product
Refer to Section 4.2 "Installation".
Refer to Section 4.3 "Wiring".
Refer to Section 4.4 "Confirming the installation and wiring".
NO
Refer to the followings:
- Section 5.2 "List of parameters"
- Chapter 7 in
"MELSEC-Q QD77GF Simple Motion Module User's Manual (Network)"
- "Simple Motion Module Setting Tool Help" of GX Works2
Refer to Chapter 6 "Sequence Program Used for Positioning Control".
Refer to Section 4.5 "Maintenance".
4 - 2