Mitsubishi Electric MELSEC-Q Series User Manual page 177

Example of setting for " Pr. 50 Setting for the movement amount after proximity dog ON"
Assuming that the " Pr. 8 Speed limit value" is set to 200 kPLS/s, " Pr. 46 HPR speed" to 10 kPLS/s,
" Pr. 47 Creep speed" to 1 kPLS/s, and deceleration time to 300 ms, the minimum value of " Pr. 50 Setting for the movement
amount after proximity dog ON" is calculated as follows:
[HPR operation]
Speed limit value: Vp=200 kPLS/s
Pr.8
Pr.46 HPR speed:
Vz=10 kPLS/s
Actual deceleration time: t = Tb
[Pr.50] Setting for the movement amount after proximity dog ON
[RJ010 mode]
When using the count method 1) or 2), set the movement amount to the HP after
the proximity dog signal turns ON.
(The movement amount after proximity dog ON should be equal to or greater than
the sum of the "distance covered by the deceleration from the HPR speed to the
creep speed" and "distance of movement in 10 ms at the HPR speed".)
Pr.47
Vz
t
Vp
Deceleration time: Tb=300 ms
[Pr.1] setting value
0 : mm
1 : inch
2 : degree
3 : PLS
[Pr.51] HPR acceleration time selection
Set which of "acceleration time 0 to 3" to use for the acceleration time during HPR.
Valid only during fast HPR. [CiA402 mode]
0 : Use the value set in "[Pr.9] Acceleration time 0".
1 : Use the value set in "[Pr.25] Acceleration time 1".
2 : Use the value set in "[Pr.26] Acceleration time 2".
3 : Use the value set in "[Pr.27] Acceleration time 3".
Chapter 5 Data Used for Positioning Control
[Deceleration distance] =
Creep speed: Vc=1 kPLS/s
Value set with GX Works2
(unit)
0 to 214748364.7 (  m)
0 to 21474.83647 (inch)
0 to 21474.83647 (degree)
0 to 2147483647 (PLS)
5 - 57
1 Vz
t + 0.01
2 1000
Movement amount for
10ms at HPR speed.
Vz Tb Vz
+ 0.01
=
2000 Vp
3
10 10 300 10 10
=
2000 200 10
3
= 75 + 100
= 175
Pr.50
: " Setting for the movement amount
after proximity dog ON" should be equal to
or larger than 175.
Value set with sequence program
0 to 2147483647 (  10
0 to 2147483647 (  10
0 to 2147483647 (  10
0 to 2147483647 (PLS)
Vz
Vz
3
3
+ 0.01 10 10
(unit)
 m)
-1
-5
inch)
-5
degree)