Table of Contents
Advertisement
5.4
Printing using
the Windows
Driver
Intermec ColorCoder V4 – Installation & Operation Ed. 1
The following restrictions may apply to features of the graphics
interface (GDI) of Microsoft Windows, when you use the printer
drive and print with ColorCoder V4.
• Colour inconsistency may result during printing of complex
data. If colour inconsistency is severe, the Windows Print
Manager can be used to improve printing.
• On some computers, cancellation of a print job created with the
printer driver may result in abnormal print during a subsequent
print job. After cancelling a print job, please reset the printer
from the printer's control panel before proceeding with printing.
• When printing with the printer driver, the following settings
should be set via the printer's control panel:
- Partition interval, see chapter 9.7.
- Number of partition sheets, see chapter 9.7.
To start printing, select the "Print...." option in the "File" menu.
1.
The dialogue box, that will be displayed differs in appearance
depending on application. Below is an example in Windows 95
where the BJ Label/Card Printer (ColorCoder V4) has been
selected as default printer:
Use this box to order the printing like with any other type of
2.
printer with one important exception:
Always specify the Copies value to 1 in this box.
Use the printer driver setup box to set the desired number of
copies (see chapter 5.3), se #3 on next page.
Chapter 5
Printing
55
Advertisement
Table of Contents
