Table of Contents
Advertisement
4.12 Print Position
Alignment,
cont'd.
K = Black
C = Cyan
M = Magenta
Y = Yellow
Intermec ColorCoder V4 – Installation & Operation Ed. 1
. Use the <Menu> key to increment a digit or switch to positive
10
value and the <Enter> key to decrement a digit or switch to
negative value. Use the <Cursor left> and <Cursor right>
keys to move the cursor between the different positions.
. After setting the correct value, press the <Cursor right> key
11
while the cursor is below the last digit. The cursor disappears
from the display panel. Press the <Enter> key to set the selected
vertical register position.
. Press the <Menu> key, and the display panel shows.
12
V-NOZZLE ADJ.
. Press the <Cursor right> key.
13
H-NOZZLE ADJ.
. Four different nozzles can be adjusted:
14
K nozzle: Just press the <Enter> key.
C nozzle: Press <Cursor right> key once, then <Enter>.
M nozzle: Press <Cursor right> key twice, then <Enter>.
Y nozzle: Press <Cursor right> key three time, then <Enter>.
One of the following four menus will be displayed.
K NOZZLE POS.= 0
C NOZZLE POS.= 0
M NOZZLE POS.= 0
Y NOZZLE POS.= 0
. Press the <Cursor right> key. A cursor appears in the menu.
15
Y NOZZLE POS.=_0
. Use the <Menu> key to increment a digit or switch to positive
16
value and the <Enter> key to decrement a digit or switch to
negative value. Use the <Cursor left> and <Cursor right>
keys to move the cursor between the different positions.
. After setting the correct value, press the <Cursor right> key,
17
while the cursor is below the last digit. The cursor disappears
from the display panel. Press the <Enter> key to set the selected
horizontal register position.
. After having set all vertical and horizontal register positions,
18
press the <Menu> key repeatedly until the display panel shows:
OFF LINE
. Proceed at chapter 4.13.
19
Chapter 4
Installation
34
Advertisement
Table of Contents
