Table of Contents
Advertisement
4.13 Stop Position
Alignment,
cont'd.
Intermec ColorCoder V4 – Installation & Operation Ed. 1
. Loosen the two screws shown in the figure and adjust the cutter
15
manually. Tighten the screws. If necessary, make further adjust-
ments by means of the control panel.
. When the stop alignment is set, press the <Menu> key repeat-
16
edly until this message is shown on the display panel.
OFF LINE
. Proceed at chapter 4.14.
17
Chapter 4
Installation
37
Advertisement
Table of Contents
