Figure 3-8 Setting Paper For Printing; Setting The Paper - Intermec 6820 User Manual

Operation

Setting the Paper

Do the following to feed the paper into the printer:
1. Press the FORM FEED button on the control panel to
2. Lower the paper bail. The top of the page should be
" NOTE:
If your paper has a preprinted logo on every page, make sure the
print head is below the preprinted logo. If not, you can adjust the
position of the paper, either by pressing the LINE FEED button, or
by using the green thumb wheel.
3. Once the paper is properly positioned, press the
4. Close the printer lid. Ensure that the paper will pass
3-14 6820 Printer User's Guide
feed the paper into the printer.
approximately 1/4" (6.4 mm) above the paper bail.
SET PAGE button, thus clearing the PAPER OUT
light, and to indicate where the top of the page is.
through the paper slot when the printer begins to
print.
Figure 3-8
Setting Paper for Printing
SECTION 3