Setting Label Gap - Intermec ColorCoder V4 Installation And Operation Manual

9.5 Setting Label
Gap
Intermec ColorCoder V4 – Installation & Operation Ed. 1
When printing labels, set the interval between labels, or the vertical
size of the detection holes in tags, according to the following
procedure. Refer to chapter 8 for information on allowed values.
. After setting the paper size according to chapter 9.4, proceed as
1
follows.
LABEL GAP SET.
. Press the <Enter> key.
2
LABEL GAP
. "03" is the default gap value for "Paper Type 1". Press the
3
<Cursor right> key. A cursor appears under the numbers on the
display panel.
LABEL GAP
. Use the <Menu> key to increment, and the <Enter> key to
4
decrement the number above the cursor. Use the <Cursor left>
and <Cursor right> to move the cursor between the digits.
LABEL GAP
. After setting all digits, press the <Cursor right> key while the
5
cursor is below the last digit. The cursor disappears from the
display panel. Press the <Enter> key to set the label gap. The
display panel now shows:
MARK/HOLE SET.
. Continued at chapter 9.6.
6
Chapter 9 Advanced Paper Settings
Label Gap
GAP
=03
=03
=05
93