Printing A Testprint - Intermec PB50 User Manual

Printing a Testprint

PB50 Mobile Label and Receipt Printer User's Guide
Chapter 1 — Using the PB50 Mobile Label and Receipt Printer
7 Press and hold the Feed button for more than two seconds to
calibrate the media.
After you have loaded media in the printer, you are ready to print a
testprint. You can choose from several testprint options for each type
of firmware. If you cannot get the testprint information to print, see
"Troubleshooting the PB50" on page
To print a testprint with a PB50 loaded with IPL firmware
1 Press the Setup button.
2 Press until you reach Test/Service.
3 Press to enter the Test/Service menu system.
4 Press to enter the Testprint Config menu.
5 Press to enter the Config menu.
6 Press to choose a testprint.
7 Press to print the Config testprint of your choice.
To print a testprint with a PB50 loaded with Fingerprint firmware
1 Press the Setup button.
until you reach Print Defs.
2 Press
3 Press to enter the Print Defs menu system.
4 Press until you reach Testprint.
5 Press to enter the Testprint menu.
6 Press to choose a testprint.
7 Press to print the testprint of your choice.
Before you can print a self test with ESC/P firmware, you need to
establish communications between the PB50 and your network. For
help, see "Establishing Communications With a Host" on page
To print a self test with a PB50 loaded with ESC/P firmware
Send the ESC EZ{TP} command to the printer.
•
42.
27.
15