Table of Contents
Advertisement
9.3
Setting Top of
Form
Intermec ColorCoder V4 – Installation & Operation Ed. 1
Use the following procedure to set the type of print paper in regard
of means for detecting the top of the form.
A: Label/Gap
Labels fitted on
backing paper
(liner) with gaps
between labels.
D:Tag/Hole
Pre-perforated tags
with detection holes
stamped out of the
paper.
. Verify that "TOP OF FORM SEL." appears on the display
1
panel, as described in chapter 9.2, then press the <Enter> key.
*A:LABEL/GAP
. Pressing the <Cursor right> key repeatedly causes the follow-
2
ing paper types to be displayed in sequence:
*A:LABEL/GAP
B:LABEL/MARK
C:TAG/MARK
D:TAG/HOLE
E.TAG/NO TOF
. When the paper type you wish to use is displayed, press the
3
<Enter> key to select this type of Top of Form. The display
panel shows:
PAPER WIDTH SET.
. Continued at chapter 9.4
4
Chapter 9
B: Label/Mark
Labels fitted on
backing paper
(liner) with black
marks printer on
the backside of
the backing paper.
E:Tag/No TOF
Continuous paper
strip without black marks
or detection holes.
Advanced Paper Settings
C: Tag/Mark
Pre-perforated tags
with black marks
printed on the
backside.
90
Advertisement
Table of Contents
