Table of Contents
Advertisement
9.4
Setting Paper
Width and
Length,
cont'd.
Intermec ColorCoder V4 – Installation & Operation Ed. 1
. "076" is the default length value for "Paper Type 1". Press the
7
<Cursor right> key. A cursor appears under the numbers on the
display panel.
PAPER LENGTH=076
. Use the <Menu> key to increment, and the <Enter> key to
8
decrement the number above the cursor. Use the <Cursor left>
and <Cursor right> to move the cursor between the digits.
PAPER LENGTH=051
. After setting all digits, press the <Cursor right> key while the
9
cursor is below the last digit. The cursor disappears from the
display panel. Press the <Enter> key to set the paper length. The
display panel now shows:
LABEL GAP SET.
. Continued at chapter 9.5.
10
Chapter 9
Advanced Paper Settings
92
Advertisement
Table of Contents
