Table of Contents
Advertisement
9.7
Setting
Partition
Interval and
Number of
Partition
Sheets,
cont'd.
Intermec ColorCoder V4 – Installation & Operation Ed. 1
. After setting all the digits, press the <Cursor right> key while
9
the cursor is below the last digit. The cursor disappears from the
display panel. Press the <Enter> key to set the partition interval.
INT. PAGE SET.
. Press the <Enter> key.
10
INT. PAGE
. Press the <Cursor right> key. A cursor appears under the
11
number on the display panel.
INT. PAGE
. Use the <Menu> key to increment, and the <Enter> key to
12
decrement the number above the cursor. Use the <Cursor
right> and <Cursor left> keys to move the cursor between
digits.
INT. PAGE
. After setting all the digits, press the <Cursor right> key while
13
the cursor is below the last digit. The cursor disappears from the
display panel. Press the <Enter> key to set the number of
partition sheets.
MARGIN SET.
. Press the <Menu> key repeatedly to return to the "OFF LINE"
14
menu.
Note!
• Do not set the partition interval to a value outside the range
determined by the set number of print copies. Only the set
number of print copies will be printed, even if the value set for
the partition interval would require a higher number of print
copies than that which was set.
• If the partition interval is more than can be printed on a single
paper roll, the number of copies to be recovered is displayed, see
chapter 7.1, when the first roll runs out. After replacing the roll,
enter this number to continue partitioning.
Chapter 9
Advanced Paper Settings
=01
=01
=02
96
Advertisement
Table of Contents
