Table of Contents
Advertisement
4.7
Turning
Printer On in
User Mode
Intermec ColorCoder V4 – Installation & Operation Ed. 1
Start up the printer in the User Mode, i.e. the mode where you print
your labels, as decribed below.
. Turn on the power to the printer by pressing the power switch on
1
the printer's front (see chapter 1.7).
. An auto-cleaning process is started, then the following message
2
appears on the display panel:
WARMING UP
. After approximately 2 minutes, the cleaning process is com-
3
pleted and a new message appears on the display panel:
READY
. The printer is now ready for normal operation.
4
Chapter 4
Installation
21
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorCoder V4 and is the answer not in the manual?