Radius-Server Timeout - Cisco CRS User Manual

radius-server timeout

radius-server timeout
To set the interval for which a router waits for a server host to reply before timing out, use the radius-server
timeout command. To restore the default, use the no form of this command.
radius-server timeout seconds
no radius-server timeout
Syntax Description
seconds
Command Default
The default radius-server timeout value is 5 seconds.
Command Modes
Global configuration mode
Command History
Release
Release 3.2
Usage Guidelines
Use the radius-server timeout command to set the number of seconds a router waits for a server host to reply
before timing out.
Task ID
Task ID
aaa
Examples This example shows how to change the interval timer to 10 seconds:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# radius-server timeout 10
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
54
Number that specifies the timeout interval, in seconds. Range is from 1 to 1000.
Modification
This command was introduced.
Operations
read, write
Authentication, Authorization, and Accounting Commands
OL-24740-01