Configuring The Source Ip Address For Ntp Packets - Cisco NCS 6000 Series Configuration Manual

Configuring the Source IP Address for NTP Packets

Command or Action
Example:
RP/0/RP0/CPU0:router(config-ntp)# no
interface pos 0/0/0/1
or
RP/0/RP0/CPU0:router(config-ntp)# interface
POS 0/0/0/1 disable
Step 4
Use one of the following commands:
• end
• commit
Example:
RP/0/RP0/CPU0:router(config-ntp)# end
or
RP/0/RP0/CPU0:router(config-ntp)# commit
Configuring the Source IP Address for NTP Packets
By default, the source IP address of an NTP packet sent by the router is the address of the interface through
which the NTP packet is sent. Use this procedure to set a different source address.
Note No specific command enables NTP; the first NTP configuration command that you issue enables NTP.
System Management Configuration Guide for the Cisco NCS 6000 Series Router, Release 5.0.x
38
Purpose
Saves configuration changes.
• When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
◦ Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
◦ Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
◦ Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Implementing NTP