Source Ip (Erspan) - Cisco nexus 3000 series Command Reference Manual

source ip (ERSPAN)

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
source ip (ERSPAN)
To configure the source IP address for an an Encapsulated Remote Switched Port Analyzer (ERSPAN)
destination, use the source ip command. To remove the source IP configuration, use the no form of this
command.
Syntax Description
ip_address
Command Default
None
Command Modes ERSPAN destination configuration mode
Command History Release
5.0(3)U2(2)
Usage Guidelines An ERSPAN destination session supports only one source IP address.
Examples This example shows how to configure a source IP address for an ERSPAN session:
switch# configure terminal
switch(config)# monitor session 1 type erspan-destination
switch(config-erspan-dst)# source ip 192.0.2.1
switch(config-erspan-dst)#
Related Commands Command
monitor session
show monitor session
show running-config
monitor
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-322
source ip ip_address
no source ip ip_address
IP address for the ERSPAN session.
Modification
This command was introduced.
Description
Creates a new SPAN session configuration.
Displays SPAN session configuration information.
Displays the running configuration information of a SPAN session.
Chapter System Management Commands
OL-29557-04