Piston Ring Installation; Piston Connecting Rod Assembly - Segway VILLIAN SSV Series Service Manual

CYLINDER HEAD, CYLINDER, PISTON CYLINDER HEAD, CYLINDER, PISTON
E E
D D
C C
B B
A A
Piston top surface
Intake side
Output

Piston ring installation

TIPS
When installing the piston ring, apply clean engine oil
to the surface. Check the clearance of the piston ring
groove (see "Measuring the clearance of the piston
ring groove"). If assembling a used piston, the carbon
deposits in the piston ring groove and the oil hole of the
oil ring groove should be cleaned fi rst
◆ Install the oil ring backing ring 【B】 in the bottom
◆ Install the bottom wiper ring 【A】 and turn it so that
◆ Install the upper wiper ring 【C】 and turn it so that
◆ Install the second air ring, the side with the mark on
Arrow towards the
exhaust side
◆ Install the first air ring, the side with the mark on

Piston connecting rod assembly

◆ Piston pin hole, connecting rod small end hole, and
◆ Insert the piston pin and install the new piston pin
Do not reuse the piston pin retaining ring, as the
retaining ring will be deformed during disassembly.
Do not over-compress the retaining ring during
installation, so as not to reduce the radial elastic force
of the retaining ring
piston ring groove so that the two ends are butt (not
overlapping), and turn the backing ring so that the
opening faces the engine output end.
the ring port faces the intake side of the piston.
the ring opening faces the exhaust side of the piston.
the ring faces upwards, and turn it so that the ring
opening faces the air inlet side.
the ring faces upwards, and turn it so that the ring
opening faces the exhaust side.
piston pin are smeared with clean engine oil.
retaining ring. Turn the retaining ring so that the
opening faces upward or downward.
CAUTION CAUTION
!
3-5-40