Install The Main Shaft Assembly; Install The Gear Assembly; Install The Right Box Body Combination - Segway VILLIAN SSV Series Service Manual

A A
A A
胶线轨迹
FRONT AXLE AND REAR GEARBOX FRONT AXLE AND REAR GEARBOX
B B
B B
A A
B B
C C
A A
B B
C C

Install the main shaft assembly

【A】 Bushing
【B】 Main shaft
◆ Tools: copper hammer.
◆ Press 【A】 into 【B】 according to the icon.

Install the gear assembly

【A】Reverse gear idler shaft assembly
【B】 Main shaft assembly
【C】 Rear axle output gear assembly
◆ First put 【A】 into the left box body according to
the fi gure, then put 【B】 into the left box body, and
fi nally put 【C】 into the left box body.
CAUTION
! !
When installing the 【C】 rear axle output gear, pay attention
to the gap between the gear and the box body to prevent
fi ngers from being pinched.

Install the right box body combination

【A】Right gearbox
【B】 Bolt M8×40
【C】 Bolt M8×60
◆ Tool: 10mm sleeve.
◆ Apply sealant according to the gluing track as shown
in the fi gure. The glue application should be uniform
and continuous, and the glue line width should be
about 1.5-2mm.
◆ Align with the positioning pin hole of the left
box body, install 【A】, and tighten the bolts in
sequence.
12N·m(1.22kgf·m,8.86ft·lb)
12N·m(1.22kgf·m,8.86ft·lb)
4 - 25
Bolt M8×40
(1.22kgf·m,8.86ft·lb)
Bolt M8×60
(1.22kgf·m,8.86ft·lb)