Install The Gear Sensor And Rotary Shaft Oil Seal; Install The Gear Set Nut - Segway VILLIAN SSV Series Service Manual

FRONT AXLE AND REAR GEARBOX FRONT AXLE AND REAR GEARBOX
A A
B B
C C
D D
E E
F F
A A
B B
C C
D D

Install the gear sensor and rotary shaft oil seal

【A】 Bolt M6×20
【B】 Gear sensor assembly
【C】 O-ring 29.6×2.4
【D】 Oil seal 38×55×7
【E】 CVT driven wheel bushing
【F】 O-ring 31×2.5
◆ Tools: 38×55×7, 10mm sleeve with oil seal guide
punch at the output end.
◆ Put 【C】 into 【B】 and then into the box body
and tighten the bolt 【A】, install 【F】 into 【E】,
first install 【G】 and then 【E】, the oil seal is
press-fi tted with an oil seal Tool to install the oil seal
in place.
12N·m(1.22kgf·m,8.86ft·lb) 12N·m

Install the gear set nut

【A】 Hex fl ange nut M22×1
【B】 Needle roller P4×29.8
【C】 Nut M33×1.5
【D】Nut M30×1.5
◆ Tools: 27mm sleeve, 46mm sleeve.
◆ After applying thread glue to the nut 【A】, tighten
it clockwise, insert 【B】 into the needle hole of
the four-axis assembly, apply thread glue to the nut
【C】 and tighten it clockwise, and apply thread
glue to the nut 【D】, clockwise Tighten.
hex fl ange nut m22×1
145N·m(14.8kgf·m,107ft·lb) 145N·m
240N·m(24.5kgf·m,177ft·lb) 240N·m
Nut M30×1.5-LH
210N·m(21.4kgf·m,155ft·lb) 210N·m
4 - 28
Nut M6×20
(1.22kgf·m,8.86ft·lb)
(14.8kgf·m,107ft·lb)
Nut m33×1.5
(24.5kgf·m,177ft·lb)
(21.4kgf·m,155ft·lb)