Remove The Intake Pipe Assembly; Install The Intake Pipe Assembly; Install Thermostat And Water Temperature Sensor - Segway VILLIAN SSV Series Service Manual

CYLINDER HEAD, CYLINDER, PISTON CYLINDER HEAD, CYLINDER, PISTON
B B
D D

Remove the intake pipe assembly

◆ Disassembly:
【A】 Bolt M6×25
A A
【B】 Intake pipe assembly

Install the intake pipe assembly

◆ Install the intake pipe assembly 【B】, and tighten
◆ Tightening torque
D i s a s s e m b l e t h e t h e r m o s t a t a n d w a t e r
temperature sensor
B B
C C
◆ Disassembly:
A A
【A】 Bolt M6×20
【B】 Thermostat cover
【C】 Thermostat
【D】 Water temperature sensor assembly
Install thermostat and water temperature
sensor
◆ Install the thermostat 【C】, the vent of the
◆ Install the thermostat cover 【B】, and tighten
◆ Install the water temperature sensor assembly
◆ Tightening torque
the bolt 【A】.
Intake pipe assembly bolt
9.8 N·m (1.0 kgf·m, 87 in·lb)
thermostat should be upward when installing,
aligned with the notch on the cylinder head.
the bolt 【A】.
【D】, and apply thread sealant when
installing.
Thermostat cover bolt
9.8 N•m (1.0kgf•m, 87 in•lb)
Water temperature sensor assembly
12 N•m (1.2kgf•m, 107 in•lb)
3-5-26