Install The Driven Bevel Gear Cover Oil Seal; Install The Driven Bevel Gear Cover - Segway VILLIAN SSV Series Service Manual

D D
E E
F F
G G
胶线轨迹
FRONT AXLE AND REAR GEARBOX FRONT AXLE AND REAR GEARBOX
Install the driven bevel gear shaft
【A】 Oil seal 27×60×7
【B】 Driven bevel gear shaft
【C】 Cylindrical pin 6×10
【D】 Driving bevel gear shaft adjustment pad 42×48×0.6
C C
【E】 Driving bevel gear
B B
【F】 Deep groove ball bearing 6307
A A
【G】 Nut M30×1.5-LH
A A B B

Install the driven bevel gear cover oil seal

【A】 Driven bevel gear cover
【B】 Oil seal 42×55×8

Install the driven bevel gear cover

【A】 Driven bevel gear cover
【B】 Bolt M8×40
【C】 Bolt M10X1.25X45
【D】 Bolt M8×125
A A
B B
C C
D D
◆ Tools: 46mm sleeve, copper hammer.
◆ Put 【A】 into 【B】 and then into the box, knock in
the cylindrical pin 【C】, install 【G】, 【F】, 【E】
in the order shown in the figure, and lock 【D】
counterclockwise.
Nut M30×1.5-LH
210N·m 210N·m(21.4kgf·m,155ft·lb)
◆ Tools: oil seal 42×55×8 punch.
◆ Install the oil seal in place using an oil seal press
tool.
◆ Tools: 10mm sleeve, 13mm sleeve.
◆ Align the positioning pin holes of the box body, install
【A】, and tighten the bolts【B】, 【C】, and 【D】
in order.
25N·m 25N·m(2.55kgf·m,18.5ft·lb) (2.55kgf·m,18.5ft·lb)
Bolt M10×1.25×45
45N·m(4.59kgf·m,33.3ft·lb) 45N·m (4.59kgf·m,33.3ft·lb)
Bolt M8×125
25N·m 25N·m(2.55kgf·m,18.5ft·lb) (2.55kgf·m,18.5ft·lb)
4 - 27
(21.4kgf·m,155ft·lb)
Bolt M8×40