Battery Installation - Segway Snarler AT6 S User Manual

Battery installation

NOTE
To reduce the chance of sparks: Whenever the battery is
removed, disconnect the black (negative) cable first. When
reinstalling the battery, finally install the black (negative)
cable.
1. Clean battery terminals with a soft wire brush and
contact cleaner, such as the Maxima Electrical
Contact / Brake Cleaner. Finally, coat the terminals
and bolts with electrical contact grease.
2. Insert the battery in the tray.
3. Connect and tighten the red (positive) cable.
4. Connect and tighten the black (negative) cable.
5. Install a clear battery vent from the vehicle to
the battery vent. (For conventional batteries only).
6. Install the battery plate;
7. Tighten the battery terminal bolts;
8. Check that cables are properly routed.
MAINTENANCE
163