Adjustment Of Gear Clearance; Disassemble; Install - Segway VILLIAN SSV Series Service Manual

B B D D
A A C C
FRONT AXLE AND REAR GEARBOX FRONT AXLE AND REAR GEARBOX

Adjustment of gear clearance

! !
If the gear gap is not adjusted well, it will aggravate
the wear of gear parts, resulting in abnormal gear
transmission noise, gear surface pitting, reduced
transmission effi ciency, and shortened overall life.
【A】 Oil seal 30×78×7
【B】 Round nut m75×1.5×6-Lh
【C】 Driving bevel gear assembly
【D】 Drive bevel gear shims
E E
【E】 Front axle box assembly

Disassemble

◆ Tool: round nut M75×1.5×6-LH sleeve;
◆ Destroy and remove A from E, then use a round nut

Install

◆ Tool: round nut M75×1.5×6-LH sleeve;
◆ Take the corresponding thickness of D according
! !
Pay attention to the scratch and damage of the oil seal during
installation. If damaged, it will cause the gearbox to leak gear
oil, which will accelerate the internal wear of the gearbox and
eventually cause damage to the gearbox. Please replace the
damaged oil seal in time.
4 - 9
WARNING WARNING
sleeve to turn B clockwise out, take out C, and then
take out D from the inner hole of E.
to the gear gap value, put D into the inner hole of
E, put C into the inner hole of E, apply tightening
thread glue on B, and then use the round nut
M75×1.5×6-LH sleeve Rotate B counterclockwise,
tighten it, reconfi rm the gear gap, install new A on E
after it is accurate (note that the oil seal lip cannot
be scratched, and the oil seal as a whole cannot
be deformed), and wipe clean the gear oil spilled
around it.
CAUTION CAUTION