DRIVE SYSTEM
【A】 cotter
【B】 nut
A
【C】 gasket
【D】 bolt
C
B
【E】 Hub mounting seat
D
E
DRIVE SHAFT REMOVAL
◆ The removal method of the front and back constant
speed drive shaft is the same;
◆ Park the vehicle in the horizontal position, with a
jack or support frame to raise the vehicle, so that the
wheels do not touch the ground, and then remove
the front tire;
◆ Remove the split pin 【A】 and nut 【B】, remove
the washer 【C】;
Bolt [B] Torque
300 N·m(30.6 kgf·m,220ft·lbs)
◆ Remove the brake caliper mounting bolt 【D】,
remove the brake caliper;
Bolt [B] Torque
70 N·m(7.1 kgf·m,52ft·lbs)
◆ Take out the rim mounting seat along the arrow
direction 【E】;
8 - 10