Start Switch; 2Wd/4Wd Drive Mode Switch - Segway VILLIAN SSV Series Service Manual

A
B
ELECTRICAL SYSTEM

Start switch

When the flameout switch is turned on, press the start
switch button and the engine starts to run
When the function fails, check the related circuit fi rst
When there is no problem in the inspection circuit, test
the internal circuit of the start switch
!
O n l y w h e n t h e f l a m e o u t s w i t c h i s i n w o r k i n g
condition,the engine can be started by pressing the start
button
→ Test whether the start switch is damaged
When the start switch is pressed, the blue, red and
yellow should be able to conduct, and when the start
button is pressed at this time, the engine can be
started under normal conditions of other functions

2WD/4WD Drive mode Switch

!
The switch is valid only when the power lock is in the
ON position
【A】2WD/4WD Drive mode Switch
【B】4WD/4WD Lock Drive mode switch
→ Test whether the 2WD/4WD switch is damaged
When the shift lever is shifted to the left,
and the 2WD switch is not pressed, the switch is in the
2WD state, at this time the blue-green and gray-white,
blue-black conduction
After pressing the two-four-wheel drive switch, the
switch is in the four-wheel drive state. At this time,
blue-green and blue-black, brown-red and brown
green can be turned on；
When the lever is shifted to the right, after the four
wheel drive lock switch is popped up, the brown-red
and brown-green, gray and gray-white, light green
brown and green, respectively, can be turned on.
14 - 25