Segway VILLIAN SSV Series Service Manual page 241

FRONT & REAR SUSPENSION
B
A
G
F
A
◆ The rocker maintenance
◆ Add grease
◆ When it is found that the lubricating grease in the
A
◆ Dedicated tool： oiling gun
When there is no proper lubrication for the suspension
joints, it needs to be fi lled with grease and maintained
regularly to avoid excessive wear of shaft sleeve.
Hub bearing replacement
If the hub bearing in the knuckle assembly and rear axle
support assembly is damaged, it needs to be replaced.
【A】split ring
【B】hub bearing
C
【C】Front knuckle
【D】Rear axle mount
◆ Take out the split ring【A】with the circlip pliers
◆ From the three openings opposite the bearing, use
Dedicated tool：Circlip plier, Bearing drive kit
Disassembly of rear axle support assembly
【E】 Rear axle support
【F】 Plain bearing
【G】 Steel wire retainer for hole Dedicated tool：Circlip
plier, Bearing drive kit
E
Check the buffer sleeve【F】, If the inner hole is
seriously worn, it needs to be replaced, and the grease
should be refi lled after assembly.
B
shaft sleeve of the suspension rocker arm and the
bearing sleeve of the wheel axle is reduced, or every
1000Km of the vehicle, it is necessary to fill the
grease through the butter nozzle in the suspension
system 【A】 using the tool.
!
the bearing driver to press out the hub bearing【B】
on the press and replace it
!
9 - 16