ELECTRICAL WIRING
Wiring check
◆ Visually inspect the wiring for signs of ablation, wear, etc.
◆ Remove each connector 【 A 】 and check for corrosion, dirt and damage.
◆ Remove each connector 【 A 】 and check for corrosion, dirt and damage.
如果损坏,请更换。
Check the continuity of the wire
Refer to the electrical schematic diagram to find the wire end suspected to be
◆
problematic.
Connect the manual tester (multimeter) to both ends of the wire.
◆
Set the manual tester (multimeter) to the on-off gear.
◆
If the reading of the manual tester (multimeter) is not 0 or the buzzer does not work, the
wire is defective if necessary, replace the wire or the main harness 【 B 】 .
ELECTRICAL SYSTEM
14 - 31