Segway VILLIAN SSV Series Service Manual page 94

CRANKCASE\CRANKSHAFT\BALANCE SHAFT
M6
M10
M8
13 13
2 2
6 6 4 4
3 3
5 5
1 1
11 11
10 10
M6
M8
◆ ◆ Align the position and load the lower crankcase. Align the position and load the lower crankcase.
◆ The rubber hammer can be gently tapped around
the crankcase to ensure that there is no gap on the
sealing surface of the upper and lower cases.
◆ ◆ Screw in four M8 bolts, eight M10 bolts, and one M6 Screw in four M8 bolts, eight M10 bolts, and one M6
bolt. bolt.
CAUTION CAUTION
!
Replace the M10 bolt each time you install the crankcase.
◆ Tighten the bolts in place in sequence.
8 8
7 7
9 9
12 12
◆ Turn the crankcase and screw 2pcs M8 bolts and
11pcs M6 bolts into the upper crankcase.
3-4-21
Bolt M10
one step:: 12 N·m (1.2 kgf·m, 8.6 ft·lb
two step:：28 N·m (2.8 kgf·m, 20.6 ft·lb
three step: turning 90°
Bolt M8
35 N·m (3.5 kgf·m, 26 ft·lb
Bolt M6
12 N·m (1.2 kgf·m, 106 in·lbs
ft·lb)
ft·lb)
ft·lb)
·lbs)