Oil Pressure; Measure Oil Pressure - Segway VILLIAN SSV Series Service Manual

ENGINE LUBRICATION SYSTEM
A A
B B
C C

Oil pressure

Oil pressure

Measure oil pressure

◆ Connect the oil pressure gauge connector 【C】 to
the oil pressure gauge 【B】
◆ Clean the area around the oil pressure sensor 【A】
and remove the oil pressure sensor
◆ Connect the oil pressure gauge connector 【C】
◆ Start the engine, make the engine reach working
temperature, observe the reading of the oil pressure
gauge
Special tools：
Oil pressure gauge，10 kgf/cm
Oil pressure gauge connector: E01GZ0031001
Oil pressure requirement (heat engine state)
More than 69 kPa (10psi) @1400r/min (rpm)
More than 276 kPa (40 psi) @7000r/min (rpm)
◆ Shutdown engine.
◆ Remove the oil pressure gauge and connector
WARNING
!
When disassembling the pressure gauge connector,
pay attention to prevent the hot engine oil from being
scalded. The hot engine oil will fl ow out through the oil
passage.
◆ Install the oil pressure sensor and tighten it to the
specifi ed torque
◆ Tightening torque
Oil pressure sensor
15 N·m (1.5 kgf·m, 11 ft·lb)
3-1-9
2
: E01GZ0030001