ENGINE LUBRICATION SYSTEM
E E
D D
C C
C C
B B
A A
B B
A A
Oil pump
Oil pump
Remove the oil fi lter assembly
◆ Disassemble:
【A】 Bolt M6×16
【B】 Oil strainer assembly
【C】 Oil strainer seal ring
Install the oil fi lter assembly
Put 【C】 on the 【B】 tube, the larger side of the outer
ring is in contact with the upper fl ange surface of 【B】
Apply a proper amount of engine oil to the outer ring of
【C】, align the position of the oil hole, and press in 【B】
Install bolt 【A】, tighten it by torque
Tightening torque
9.8 N•m (1.0kgf•m, 87 in•lb)
Remove the oil pump assembly
Disassemble
【A】 Bolt M6×20
【B】 Oil pump components
◆ Remove the bolt 【A】, turn 【B】 to an appropriate
angle, and take it out after the chain is disconnected
◆ Disassemble:
【C】 Bolt M6×20
【D】 Washer 6.5
【E】 Oil pump driven sprocket
Install the oil pump assembly
◆ Align the position of the 【E】 notch with the upper
shaft of 【B】, and install 【E】 and 【D】
◆ Apply thread fastening glue to the thread of 【C】,
screw in the bolt, and tighten it according to the torque
◆ Turn 【E】, it should turn fl exibly and should not be
stuck
◆ Put 【E】 into the chain, screw in the bolts 【A】 in
order, and tighten to the specifi ed torque
◆ Tightening torque
9.8 N•m (1.0kgf•m, 87 in•lb)
3-1-10
Bolt 【A】
Bolt 【C】