Segway VILLIAN SSV Series Service Manual page 236

A
B
FRONT & REAR SUSPENSION
Absorber disassembly
【A】 Airbag mounting bolt M8x25
【B】 Shock absorber mounting bolt
◆ Raise a vehicle with a jack or support frame so that
the wheels do not touch the ground.
◆ Remove the upper and lower installation bolts of the
shock absorber with A tool 【A】 and 【B】
◆ Take out the front shock absorber
Assembly absorber installation
◆ Put the upper end of the front shock absorber into
the frame mounting seat, and set the bolts and nuts
【B】
◆ The lower end of the front shock absorber is
installed on the front rocker arm mounting seat, and
the bolts and nuts are covered 【B】
◆ Install the shock absorber air bag on the frame
mounting seat, and set the bolt 【A】
◆ Tighten the upper and lower mounting bolts and nuts
with tools.
◆ Front and rear shock absorbers are disassembled in
the same way.
Shock absorber fi xed nut torque
115 N·m（11.5kgf·m，83ft·lb）
Ch eck th e ad justa bl e pne um ati c sho ck
absorber
◆ Check the upper and lower mounting seat
◆ If the joint bearing combination is damaged, replace
them.
【A】 wire retainer
【B】 Plain bearing combination
9 - 11