Install The Parking Shaft And Shift Drum Assembly - Segway VILLIAN SSV Series Service Manual

FRONT AXLE AND REAR GEARBOX FRONT AXLE AND REAR GEARBOX
A A
A A
B B
C C
D D
A A
B B
B B
C C
C C
D D
E E
Install the parking shaft and shift drum
assembly
【A】 Washer 15×28×1
【B】 shift drum
【C】Parking guide shaft
◆ Assemble 【A】 【B】 as shown in the fi gure and
install it into the left box body, and then put 【C】
into the left box body.
CAUTION
! !
When installing, check that the roller part of the HR gear shift
fork, L gear shift fork, and push rod seat assembly should be
in the guide groove of the red-painted part of the shift drum.
Install the parking shaft and shift drum
assembly
【A】 Steel ball 9.5
【B】 Gear positioning spring
【C】 Aluminum washer 14×21×1.5
【D】 Gear positioning bolt
◆ Tool: 14mm sleeve.
◆ Put 【A】, 【B】, and 【C】 into 【D】 in the order
shown in the fi gure, and then into the left box.
A s s e m b l e t h e r e v e r s e g e a r i d l e r s h a f t
assembly
【A】 Cylindrical pin 6×10
【B】 Reverse gear idler shaft
【C】 Needle roller bearing K30×35×17
【D】Reverse gear idler
【E】 Washer 26×44×3
◆ Tools: copper hammer.
◆ After typing 【A】 into 【B】, load 【C】, 【D】,
and 【E】 in the order shown in the fi gure.
4 - 24