Mitsubishi Electric MELDAS 600M Series Instruction Manual page 95

(4) Checking one block at a time ( Check step )
(5) Canceling the program check ( Check reset )
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
1)
Search the program with the
same procedure as method
(3).
2)
Press the menu key
.
Check step
State during one block check
3)
Press
Check step
repeatedly.
(Note 1) If
Check continu
end of the program.
(Note 2) The workpiece coordinate position counter and G command modal (Group 03, 01,
07, 09) are displayed during the check step.
1)
Press the menu key
.
Check reset
search engine
Only one block of the program is checked, and the path
for that block is displayed. The menu is highlighted
during the check.
When one block of checking is completed, a message
appears, and the menu highlight returns to normal.
State when one block check is completed
The program is checked block by block.
When the check is completed, a message appears,
and the check mode is canceled.
The menu highlight returns to normal.
is pressed midway, the program is checked continuously to the
The check mode is canceled, and the menu highlight
returns to normal. The message such as "Checking"
disappears.
I – 80
Check stopped
Pr ogr am chec k c om plet ed