Mitsubishi Electric MELDAS 600M Series Instruction Manual page 6

7. Items related to faults and errors
8. Items related to maintenance
Downloaded from ManualsNet.com
If the BATTERY LOW warning is output, save the machining programs, tool data and
parameters to an input/output device, and then replace the battery. If the BATTERY
alarm occurs, the machining programs, tool data and parameters may be damaged.
After replacing the battery, reload each data item.
If the axis overruns or makes an abnormal noise, press the emergency stop button
immediately, and stop the axis.
Do not apply voltages on the connector other than those indicated in this manual.
Doing so may lead to destruction or damage.
Incorrect connections may damage the devices, so connect the cables to the
specified connectors.
Do not connect or disconnect the connection cables between each unit while the
power is ON.
Do not connect or disconnect any PCB while the power is ON.
Do not replace the battery while the power is ON.
Do not short-circuit, charge, overheat, incinerate or disassemble the battery.
Dispose of the spent battery according to local laws.
Do not replace the backlight while the power is ON.
Dispose of the spent backlights according to local laws.
Do not replace the cooling fan while the power is ON.
Dispose of the old cooling fan according to local laws.
Do not replace the HDD while the power is ON.
Dispose of the old HDD according to local laws.
search engine
CAUTION