Mitsubishi Electric MELDAS 600M Series Instruction Manual page 485

Error No.
PR0360
PR0380
PR0382
PR0383
PR0384
PR0385
PR0386
PR0390
PR0391
PR0392
PR0393
PR0394
PR0395
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 3. Alarm Messages
Message
A mirror image command (G50.1,
No program mirror
G51.1) was issued even though
spec.
there are no programmable mirror
image specifications.
No corner R/C spec. A command was issued for corner
rounding or corner chamfering
even though there are no such
specifications.
No corner movement The block next to corner rounding/
chamfering is not a movement
command.
In the corner rounding or
Corner movement
chamfering command, the
short
movement distance was shorter
than the value in the
corresponding command.
When the corner rounding or
Corner next
chamfering command was input,
movement short
the movement distance in the
following block was shorter than
the corner rounding or
chamfering.
Corner rounding or chamfering
Corner during
command was given during G00
G0/G33
or G33 modal.
The corner R/C movement cannot
Can't execute corner
be created.
R (C)
A geometric command was
No geometric spec.
issued even though there are no
specifications.
An arc command was issued with
No geometric arc
the geometric command even
spec.
though there are no arc
specifications.
Angle less than 1 The angle difference of two
straight lines in the geometric
deg (GEOMT)
command was within 1°.
The second block of the
Inc value in 2nd
geometric command was an
block (GEOMT)
incremental value command.
The second block of the
No linear move
geometric command was not
command (GEOMT)
linear.
The plane selection horizontal
Illegal address
axis and plane selection vertical
(GEOMT)
axis are not commanded in the
second block of the geometric
command.
There is no A command in the
second block of the geometric
command.
search engine
Details
• Check the specifications.
• Check the specifications.
• Remove the corner rounding or
chamfering command from the
program.
• Replace the G01 command by
the block succeeding the corner
rounding/chamfering command.
• Make the corner rounding or
chamfering less than the
movement distance since this
distance is shorter than the
corner rounding or chamfering.
• Make the corner rounding or
chamfering less than the
movement distance since this
distance in the following block is
shorter than the corner rounding
or chamfering.
• Reconsider the program.
• Reconsider the program.
• Check the specifications.
• Check the specifications.
• Correct the geometric angle.
• Command the second
geometric block with an
absolute value.
• Command G01 in the second
geometric block.
• Reconsider the program.
IV – 43
Remedy