Mitsubishi Electric MELDAS 600M Series Instruction Manual page 118

2.10.1 Turning control parameters ON/OFF
(1) Operation method (To turn control parameters "#310001 Initial inch∗" ON)
(Note 1) If the Setting valid menu or
(Note 2) If another screen is opened, including the Control parameter 1 and 2 screens, the
(Note 3) The cursor will not appear in modes other than the parameter setting mode. If the menu
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
1)
Press the menu key
Setting valid .
2)
Press "Y" or INPUT .
3)
Press the cursor keys
and to move the
↑ ↓
cursor to "#310001".
4)
Press the menu key
To turn OFF, press the menu
key .
OFF
mode, the parameter setting mode will be canceled.
parameter setting mode will be canceled.
key or
ON OFF
parameter setting mode will appear.
search engine
A message confirming the start of parameter setting will
appear. The menu key Setting valid will be highlighted.
The parameter setting mode will be entered. The cursor
will appear at the parameter No. position. The menu
keys and
ON
The parameter at the cursor position will turn ON, and
.
ON
the parameter name will be highlighted.
key is pressed again during the parameter setting
is pressed in this state, a message indicating that the mode is not the
I – 103
will appear normally.
OFF