Mitsubishi Electric MELDAS 600M Series Instruction Manual page 352

5.7 Cycle start and feed hold
Use the CYCLE START switch to start automatic
operation (program run or MDI). Automatic operation
is executed by turning ON the switch. Also use this
switch to restart the operation when it has been
stopped using the FEED HOLD switch, or from an
automatic operation stop state.
The CYCLE START switch is validated when the switch is turned ON, then OFF.
Use the FEED HOLD switch to temporarily stop automatic operation (for example, deceleration stop
of the control axis during automatic operation). To restart operation, use the CYCLE START switch.
5.8 Feed axis selection
Use the FEED AXIS SELECT switch to start the
controlled axis during manual operation. While the
FEED AXIS SELECT switch is ON, the selected
controlled axis is moved. When the switch is turned
OFF, the controlled axis movement stops.
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
5. Operation Panel Switches in Operation Mode
search engine
CYCLE START
II – 19
FEED HOLD
FEED AXIS SELECT