Mitsubishi Electric MELDAS 600M Series Instruction Manual page 168

Number
34 0006 G76/87 shift
34 0007 Soft limit
34 0008 Soft limit (–)
34 0009 Soft limit (+)
34 0010 G60 shift
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Name
This designates the tool shift direction (–) for tool
(–) relief after spindle orientation in the fixed cycle G76
(fine boring) and G87 (back boring).
(-, +)
(-, )
This selects the stored stroke limit II function set in
invalid 340008 and 340009.
This sets the coordinates of the (–) direction in the
moveable range of the stored stroke limit II or the
lower limit coordinates of the prohibited range of
stored stroke limit IIB.
When the stored stroke limit IIB function is selected,
the prohibited range will be between two points even
when 340008 and 340009 are set in reverse. When II
is selected, the entire range will be prohibited.
Soft limit outside
(340011=0)
Basic machine
coordinate system
−X
When G60 (uni-direction positioning) is commanded,
amount this sets the last positioning direction and distance for
each axis.
G60 shift amount
search engine
3. Setup Screens
Details
Y
( , +)
(+, +)
X
(+, )
(+, -)
(-, -)
( , -)
:No shift setting
Soft limit inside
(340011=1)
+Y
340008(Y)
M
+X
−Y
Movable area
Commanded end point
Command start point
I – 153
Setting range (units)
0: Shift direction (+)
1: Shift direction (–)
0: Valid
1: Invalid
–999999.999 to
999999.999 (mm)
When the same value
(other than 0) is set in
340008 and 340009, this
function is invalidated.
(Ex.) 340008 = 10.
340009 = 10.
M
340009(Y)
340009(X)
340008(X)
–999999.999 to
999999.999 (mm)