Mitsubishi Electric MELDAS 600M Series Instruction Manual page 171

Number
33 0012
33 0013
33 0014
33 0015
33 0016
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Name
Arc finish pt This sets the tolerable radius error amount of the arc
error command end point.
When the center coordinates of the arc are
designated
Start point
When the arc radius (R) is designated
Start point
3-dimen-sio A denominator variable by the three-dimensional tool
nal compen radius compensation
P value in Vx = i × r/p, Vy = j × r/p, Vz = k × r/p
Vx, Vy, Vz: XYZ axis or vector of parallel axes
i, j, k: Program command value
r: Compensation amount
When the setting value is "0": P = √ i
F cmnd mgf This multiplies the commanded F command value
type /min (per minute) using no decimal points.
Normal C This sets the length from the center of the C axis
axis turn R (spindle) to the tip of the tool.
This is used in the turning speed calculation of the
block seam during normal line control type II.
Norm C insrt During C axis normal line control, this sets the radius
radius of the arc automatically inserted in the corner.
This is only valid for normal line control type I.
search engine
3. Setup Screens
Details
Arc error set in the parameters
End point
Start
point
End point radius
radius
Arc error set in the parameters
End point
Radius(R)
Distance between
the start point and
end point
2
I – 156
Setting range (units)
0 to 1.000 (mm)
(Note)
When "0" is set, it is
processed as
0.100mm.
Set a smaller value
for more detailed
control.
0 to 999999.999 (mm)
2 2
+ j + k
0 : 1-fold
1 : 1/10-fold
2 : 1/100-fold
0 to 999999.999 (mm)
0 to 999999.999 (mm)