Mitsubishi Electric MELDAS 600M Series Instruction Manual page 261

4.2.4 Inserting data
(1) Operation method
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Move the cursor to the
position where data is to be
written.
2)
Press the INSERT key.
3)
Set the data.
4)
When the setting is
completed, press the
key.
(Note 1) The data is not saved in the NC memory at this point. (It will be erased when the
power is turned OFF.)
To save the data in the NC memory, press
The method for saving with the
parameter "Program save type".
(Note 2) Up to 256 characters can be set in one line.
(Note 3) The insertion mode will be finished if a key such as
↑ or ↓ key pressed.
search engine
4. Edit Screens
The insertion mode is entered.
INS appears at the top of the screen.
The message "Editing" appears when setting is started.
The data is set from the position of the cursor. Data at
the area is overwritten.
The cursor moves one space to the right as the data is
set.
The set data is fixed.
The cursor does not move, but if there is no EOB ( ; ) at
INPUT
the end of the line, it will be added. Then, the cursor
moves to the next line.
The move returns to the overwrite mode, and the
message "Editing" disappears.
(The message may not disappear depending on the
"Program save type".)
INPUT
I – 246
.
Save file
key can be selected with the operation
,
DELETE C•B ESC
, ,
INPUT