Mitsubishi Electric MELDAS 600M Series Instruction Manual page 86

M code
00
01
02
30
96
97
98
99
* : Indicates the codes that should be selected or that are selected in the initial state.
** : Codes that should be selected or that are selected in the initial state by the control parameters.
(Note 1) The deceleration time in the exact stop check mode is not accumulated, so this causes an
(Note 2) If there is a program parameter input, check the parameter after calculation.
(Note 3) The thread cutting mode is not cumulated.
(Note 4) The automatic tool length measurement is not cumulated.
(Note 5) The deceleration time in the exact stop check mode causes an error in the cumulated time.
(Note 6) The corner deceleration time is not cumulated in the high accuracy control mode, so an error
(Note 7) Even with automatic corner override, the time is calculated by assuming a 100% override.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Calcu-
Machining center format I
Group
lation
(Standard format)
– Program stop
– Optional stop
– Program end
– Program end
– Macro interrupt ON
– Macro interrupt cancel
– Subprogram call
– Subprogram return
error.
occurs.
Thus, an error occurs.
search engine
2. Monitor (Operation) Screens
: Valid for calculation
Function
I – 71
: Special process
Machining center format II
(M2/M0 format)
Same as left
Same as left
Same as left
Same as left
I ON
I OFF
(G22)
(G23)
: Invalid