Searching For Character Strings - Mitsubishi Electric MELDAS 600M Series Instruction Manual

4.2.7 Searching for character strings

(1) Operation method
(2) Notes when searching
1)
2)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Press the menu key
String search .
2)
Set the character string to be
searched for, and press the
key.
INPUT
3)
To continue searching, press
the key again.
INPUT
4)
To end the search, press the
menu key.
If the designated character string is not found, a message appears.
The character string containing the designated character string is searched for regardless of the
previous and next characters. Thus, if "G2" is designated, G20 to G29, G200, etc., will be
search targets.
Example of character string data setting
Designated
character string
N10 Character string containing "N10", such as "N10", "N100", etc.
N10 X100. Character string "N10 X100."
X–012.34 Character string "X–012.34" ("X–12.34" is not searched for.)
search engine
4. Edit Screens
The menu is highlighted.
The character string is searched downward from the
character string after the current cursor position.
When the character string is found, the program is
displayed with that character string at the head.
If the corresponding character string is not found in the
program, a message appears.
The next corresponding character string is searched for.
The search finishes when the end of the program is
reached.
(Note) It is not possible to return to the head of the
program and resume the search. To search
from the head of the program, move the cursor
to the head of the program and carry out the
search operation again.
The menu highlight returns to normal, and the
character string in the data setting area disappears.
The search mode is held until the menu key is pressed.
(The character string remains in the setting area.)
Example of character string to be searched
I – 250