Table of Contents
Advertisement
5.8 Waveform display screen (Visual analyzer screen)
On this screen, the data set as the condition is sampled at the sampling rate cycle and the data
waveform is drawn.
1. Sampling
data
4. Waveform
display area
(1) Display items
1. Sampling data
2. Display mode
3. Horizontal scale
4. Waveform display
area
5. Vertical scale
6. Center display
7. Synchronization error
P-P
Downloaded from
ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Visual analyzer
Data
Ch1
S1/S2/Command error
Ch2
X/Positon command
Ch3
Y/Positon command
(5)
(0)
(-5)
RDY:MEM :
Continu
Single
samplng
samplng
Display item
The sampling data set on the setting screen is displayed.
This displays the channel display mode to be sampled. The mode is
changed with the menu keys, but cannot be changed while sampling.
The horizontal scale set on the setting screen is displayed.
When "AUTO" is set on the setting screen, the automatically calculated
horizontal scale will appear.
The waveform is plotted.
Waveforms for up to three channels can be displayed.
The vertical scale is displayed.
When there are more than seven digits, an exponential with two digits
after the decimal point will be displayed.
The value of the waveform display area's center (right
displayed.
When there are more than seven digits, an exponential with two digits
after the decimal point will be displayed.
This appears when synchronous tap error is set for the data on the
setting screen.
The synchronous tap error P-P value is displayed.
search engine
5. Diagnosis Screens
6. Center
display
Monitor Setup
Center
V-scale/div
12345678
12345678
Disp mode
-2.34E10
1.00E10
H-scale
1.00E10
-1.00E10
Syn err P-P
<
>
Wave
Display
Scroll
Scroll
clear
mode
Details
I – 291
5. Vertical
scale
Edit
Diagnos
Mainte
Ch1/Ch2/Ch3
0
ms/div
0
12:34
To cond
Re-disp
set
(0)) is
2. Display mode
3. Horizontal
scale
7. Synchronization
error P-P
Advertisement
Table of Contents
